• You're all caught up!

How do I Replace a Cable on My Weight Machine?

author image Daniel Barrows
Daniel Barrows has been working as a freelance writer for businesses in the Southern California area for over two years. He has also published articles online for websites like eHow.com and Answerbag.com. He has received a Bachelors of Arts in English from the University of California, Berkeley.
How do I Replace a Cable on My Weight Machine?
A woman is training on a cable machine at a gym. Photo Credit LUNAMARINA/iStock/Getty Images

Weight machines come in a variety of sizes and shapes, some intended for use in the home, others designed for the gym. However, most models share certain basic design characteristics, such as a weight stack connected to a handle or pull bar through a series of pulleys and cables. These cables are often kept at a high tension level and may wear out with regular use. Attempting to use a worn cable on a weight machine is dangerous, and you should install a replacement cable as soon as possible.

Step 1

Stand by the weight stack, which is located at the rear of the machine. Remove the pin from the weight tube. Check the end of the cable for a tensioner; loosen the tensioner to add some slack to the cable. Use an open-end wrench and pliers to loosen the nut or casing securing the end of the cable to the weight tube. Remove the end of the cable from the weight tube.

You Might Also Like

Step 2

Trace the cable upward until you come to a pulley. Note how the cable is looped over the pulley, then lift the cable free. Continue working along the cable's path until you have lifted the cable free of all the pulleys.

Step 3

Use the open-end wrench and pliers to disconnect the cable from its anchor point; if the cable was attached to a handle or bar, place the accessory on the ground. Remove the cable and set it aside.

Step 4

Fit one end of the replacement cable into the connector end of the anchor point. Use the open-end wrench and pliers to secure the cable to the anchor point. Loop the length of cable through the pulleys, following the same path the old cable used.

Step 5

Insert the remaining end of the cable into the weight tube. Use the open-end wrench and pliers to secure the cable to the weight tube. Insert the previously removed pin back into the weight tube. Turn the cable's tensioner to remove any slack.

Related Searches

LiveStrong Calorie Tracker
THE LIVESTRONG.COM MyPlate Nutrition, Workouts & Tips
  • Gain 2 pounds per week
  • Gain 1.5 pounds per week
  • Gain 1 pound per week
  • Gain 0.5 pound per week
  • Maintain my current weight
  • Lose 0.5 pound per week
  • Lose 1 pound per week
  • Lose 1.5 pounds per week
  • Lose 2 pounds per week
  • Female
  • Male
ft. in.


Demand Media