Testing a new pair of inline skates consists of performing the basic turning maneuvers and stopping techniques. Properly testing your inline skates will allow you to find any defects and ensure your skates do not malfunction during the riding process. Testing your inline skates will ensure they will roll smoothly and straight. Inline skates that are not performing properly can cause serious injury to a skater. Wearing protective gear during the skating tests will keep you safe.
Step 1
Place your inline skates on a flat surface. Grab the front wheel of your left inline skate. Roll the wheel back and forth with your thumb to ensure it spins smoothly. Pull on the wheel to make sure that it has been tightly fastened in place on the bottom of your inline skate. Repeat this process for each of the remaining seven wheels of your two inline skates.
Step 2
Loosen the straps or laces of your inline skates and insert your feet into them. Tie the laces of the skates or fasten the straps in place. Pull on the laces or straps to ensure they remain fixed in place. Locate the brake pads behind the back wheel of each skate. Pull on the brake pads to make sure they have been properly secured.
Step 3
Stand up and onto your two inline skates. Push off the cement with your inline skates to roll forward slowly. Place your inline skates next to each another to guarantee the skates naturally roll straight. Lean your knees to the left to see if your inline skates can successfully turn. Lean your knees to the right to test the inline skate's right turning ability.
Step 4
Raise the front wheel of your left inline skate until the brake pad makes contact with the ground. Put pressure on the brake pad to test its ability to decrease your rolling speed. Push off the cement with your inline skates to regain a steady pace. Lift the front wheel of your right inline skate to activate your right brake pad.
Step 5
Repeat these turning movements and braking techniques to test your inline skates' durability and construction.
Things You'll Need
- Knee pads
- Helmet
Member Comments