If you buy your skis and ski boots at the same time, chances are the store where you purchased them set your bindings to fit. But if you have worn out your boots and are considering a new pair, adjusting the boots to fit your ski bindings isn't hard, but it does need to be precise.
Step 1
Measure your height and weight and write down the figures.
Step 2
Record your age under your height and weight.
Step 3
Determine your skier type and make note of it. Skier type is generally recognized as one of three categories: I, II and III. Type I skiers are cautious and ski at lower speeds on easier terrain; Type II are considered average/moderate skiers, who can ski on different terrain at a variety of speeds and do not fit all the requirements of Type I or III skiers; Type III skiers ski aggressively at mainly higher speeds on steeper, more challenging terrain.
Step 4
Calculate your DIN measurement. DIN stands for Deutsche industrial norm and it is a general chart used to find the correct settings for ski bindings based on an individual's height, weight, age and skier type. You can also check with the company that made your skis to see if it uses a particular version of the DIN chart.
Step 5
Adjust the DIN screws at the heel and toe of your ski binding to the correct setting.
Step 6
Test the new binding setting by putting on your boot, clipping it into the bindings and shaking the ski back and forth above the ground. You should do this again when you are on the snow.
Tips and Warnings
- Have a professional check your work the first time you reset your bindings yourself to make sure you are doing it correctly.
- Bindings that are too loose or too tight for your skiing ability can lead to serious injury on the slopes. If you are unsure of your ability to set your bindings, have a professional check your work.
Things You'll Need
- Skis
- Ski boots
- Tape measure
- DIN chart
- Pen and paper
- Screwdriver
Member Comments