Stringing lacrosse mesh involves lacing the mesh to the lacrosse head using strings from a kit. The kit includes plastic-tipped nylon tying strings that thread through the tying holes in the lacrosse head. Each string is secured in place using an overhand knot. Should you miss a loop when lacing the mesh, simply back up and start again. Lacrosse kits come with mesh netting and tying strings in different color combinations. A good all-around mesh for catching the throwing is the defense-attack mesh with eight diamonds across.
Step 1
Identify the tying strings by diameter and length. The largest is a top-tie string that is doubled for added strength. The smaller sidewall strings come in 18-inch lengths and are used in single strands. Depending on the particular kit, you may find a shorter bottom string or an extra side string for lacing the bottom of the mesh.
Step 2
Stretch the mesh netting in both directions and lay it atop the head of the stick. The mesh is oversize, which allows you to create a pocket to any depth you like. The mesh is trimmed after the stringing is complete.
Step 3
Fold the mesh across the top to create a double course of diamonds. Double the top-tie string and join the ends with an overhand knot. Thread the doubled end of the top-tie string through the first hole at one side of the head. Pull it through all the way through to seat the knot against the outside of the head.
Step 4
Position the doubled course of mesh at the top of the head. Thread the doubled end of the top-tie string through the first set of diamonds at one side of the head and up through the first lacing hole at the top of the head. Continue to lace the mesh across the top of the head in this way. Tie an overhand knot in the end of the top-tie string at the outside of the head.
Step 5
Pull the end of the mesh over the lower face of the head to position it for tying the sidewall strings. Tie an overhand knot near the end of a sidewall string. Insert other end of the string through the bottom hole at one side of the head. Pull the string through to seat the knot against the outside of the head.
Step 6
Lace the sidewall string through each diamond and the corresponding hole at the side of the head as you work from the bottom up. Tie the string off at the top, outside edge of the head with an overhand knot. Repeat this with the remaining sidewall string and lace the opposite side of the mesh to the opposite side of the head. Tie the string off with an overhand knot against the outside of the head as before.
Step 7
Double the mesh across the bottom edge of the head and hold it in place with one hand. Create the desired pocket in the mesh using your fist or a lacrosse ball. Allow the mesh to remain in the shape of the pocket.
Step 8
Tie an overhand knot near the end of the bottom string. Insert the other end through the first hole at the bottom of the head. Pull the string through to seat the knot at the outside of the head.
Step 9
Lace the bottom of the mesh by threading the bottom string through each of the doubled diamonds and the corresponding holes, working across the bottom of the head. Tie the string off with an overhand knot against the outside of the head. Trim the excess mesh above the bottom ties with scissors.
Tips and Warnings
- Consult an experienced stringer or refer to the provided illustrations for lacing patterns used with top-tie, sidewall and bottom strings.
Things You'll Need
- Scissors
Member Comments