Secrets to Tender Breaded Pork Chops

Skilled cooks know that breading delicate cuts of meat provides a number of beneficial results. The crisp outer coating traps steam in the meat, keeping it moist and provides protection against overcooking. Breaded chops can be fried or baked, for a healthier alternative, but either way, the meat will remain juicy, tender and flavorful when prepared correctly.

Selection

There are several cuts of pork commonly sold as pork chops or pork steaks. Most lower-cost cuts come from the shoulder, or the less desirable end of the sirloin. Better chops are usually cut from the rib or loin, which are the tenderest large muscles on the hog. Remember to specify boneless chops, if you're buying rib chops for breading. Choose chops that show fine lines of fat, referred to as "marbling," running all through the chop. Well-marbled meat is moist and tender, and most of the fat renders out during cooking.

Preparation

Loin chops and rib chops usually have a thick edge of fat on one side. Leave a thin strip to moisten your chop, and trim the rest away. Under the fat is a layer of connective tissue which often contracts when heated, and makes the chops curl up and cook unevenly. Avoid this by using a sharp knife to make shallow cuts through the fatty side of the chop, just deep enough to penetrate the layer of connective tissue. If there is visible gristle, either trim it away or use the tip of your knife to cut it in a few places.

Tenderizing

There are many ways to make tender chops even more so. Pound the chops lightly with the smooth side of a meat mallet or a rolling pin wrapped in plastic. This parts the muscle fibers slightly, tenderizing the pork. Many meat shops sell a jacquard tenderizer, a tool with a number of sharp pins that pierce the meat and cut the fibers. Ask your butcher to run the chops through his own tenderizer, if you'd rather not take the extra time. Avoid meat tenderizing crystals, which tend to make the chops soft and mushy in texture.

Breading

The goal of breading pork chops is to make a continuous coating that will adhere to the meat, trap moisture in the chops and crisp up nicely on the outside. Dredge the chops in flour and shake off any excess. Second, dip the floured chops into a bowl filled with milk or beaten egg. Let the excess drain. Finally, coat the chops evenly by pressing them into a pan of fine breadcrumbs or panko, turning them to cover both sides. Refrigerate the chops for at least 30 minutes and preferably two hours before cooking, which helps the coating adhere.

Cooking

Thin chops are best cooked at a relatively high heat, either panfried or baked at 400 degrees F in the oven. Once the coating is crisp, the chops should be cooked through. Thicker chops require a 375 degree F oven, and can take up to 20 minutes depending on their thickness. When a meat thermometer shows 145 degrees F at the thickest part of the chop, it's done medium-rare. As of 2011, the USDA now considers this a safe temperature for pork. Those who prefer their pork well done can continue to 160 degrees F, but the chops won't be as tender.