Baseball is played in a variety of conditions, ranging from hot and humid to wet and cold. These conditions are tough on a leather baseball glove, and can lead to damage. If a glove becomes damaged, it can be more cost-effective to repair it instead of buying a new glove. Following a step-by-step procedure to replace and condition the leather can make the glove look like new.
Step 1
Use a pliers to remove the old laces. Over time, laces become worn out and can cause the glove to lose its flexibility. Discard the laces after removal.
Step 2
Treat the new laces with petroleum jelly. This will soften the laces which will make them easier to use. Use the leather awl to insert the new laces in the same pattern as the old laces. Tie a knot at both ends to keep the laces from moving.
Step 3
Apply a liberal amount of petroleum jelly to the interior and exterior of the glove. Work the petroleum jelly into every space, hole and pore to provide protection for the leather. Wipe off any excess petroleum jelly with a towel.
Tips and Warnings
- Avoid getting the laces too tight, as this can increase the time needed for the break-in period. Make a mental note of the lacing pattern before removing the old laces. Apply additional coats of petroleum jelly as needed to keep the leather conditioned.
- Only use approved leather conditioners to condition the glove.
Things You'll Need
- Pliers
- Leather awl
- Laces
- Petroleum jelly
- Towel
Member Comments